converitng a webber gas grill from propane to naturnal gas

Here are two typical manufacturer’s gas conversion kit warning notices Watch out: Converting a gas appliance is dangerous if not done correctly and in accordance with the manufacturer’s instructions. When converting an appliance from using a lower pressure natural gas fuel supply to a higher pressure LP or propane gas fuel supply, the new orifices will be smaller in diameter to accommodate the higher pressure of the fuel supply without releasing too much fuel too quickly. Read Also: Where To Buy Weber Grill Replacement Parts The inlet size is the interface or the size/type of the threads where you attach the valve. The orifice diameter is the internal opening of the valve and is used to calculate the flow capacity of the valve. The orifice hole size determines the BTU rating and the gas type of the grill. You cannot operate a gas grill without an orifice. Once happy that all is in the correct place and routing, turn the gas valve to on. Connect the other end of this hose to your new NG outlet connection valve.If orifices are supplied simply screw them into the valves, and be sure not to over tighten as you will strip the thread on the orifices.If they are loose fitting be sure to take it easy, so the jets do not become rounded, and a quick squirt with some penetrating fluid should assist with removal. These are mass-produced, and unfortunately, their tolerance can be rubbish, so use a good quality ¼ inch socket if it fails to fit tightly onto the jets. Remove them with the orifice removal tool that comes with the kit. Set deep within the burner connection hole will be the orifices, these are small and usually brass.If they resist, double check all springs and clips have been removed, as you dont want to damage them. The burner tubes then lift out and disconnect from the gas valves with a firm pull. Remove the rear hitch pins from the burner tubes and any front ones that may be hidden from view.They have simple hitch pins that slide out with a firm push. Remove any carry over tubes if you have them.Open the lid of the grill and remove the warming rack, cooking grates and flame tamers, so you have clear access to the burner tubes and other connections.

Turn all gas control knobs to the off position and switch the LP tank off before you disconnect and remove.5 Final Thoughts Fitting The Kit And Connecting The Grill.If youre not confident, many plumbers and gas companies can make the conversion for you.You should be capable, just follow the videos below. An official kit from your grills manufacturer is recommended to convert from propane to natural gas.Make sure your grill is convertible not all are!.You must make sure you have a mains gas supply, or can get one, before you start.Key Takeaways for Converting from Propane to Natural Gas

Converitng a webber gas grill from propane to naturnal gas